|
PART I GENERAL
1.1 Scope of Work
A. The work required includes furnishing and installing bullet resisting Teller
(transaction) Window Assemblies of the sizes and quantities indicated.
B. The bullet resistant teller window assemblies must be Underwriters Laboratories
listed and bear a U.L. Label for the
(specify to select one:
MPSA, HPSA, SPSA or HPR) ballistic threat level as defined by the standard of
Safety U.L. 752 bullet resistant equipment.
1.2 Submittals
A. Provide the manufacturers specifications, data and other information which
substantiates compliance with the specified performance requirements.
B. Provide approval drawings that indicate sizes, details and installation
procedures for the bullet resistant teller window unit(s) required.
PART II PRODUCTS
2.1 Manufacturers
A. Provide the products of the following manufacturer or equal;
1. National bullet Proof, Inc. (800-323-2648), fax 708- 430-3406 (Note to
specifier: insert model numbers in this paragraph.)
2.2 Bullet Resistant Window Framing
A. Materials - All bullet resistant frames will be manufactured from Balistex(R) 38P
bullet resistant steel in accordance with ULŪ 752. (For higher ballistic
levels, delete ULŪ 752 and add: "The manufacturers independently tested
assemblies to resist the specified ballistic level.")
B. Construction -
1. The window framing shall be framing type AFT is manufactured by NATIONAL
BULLET PROOF, INC., 1-800- 323-2649, or equal.
2. The framing shall be welded and include all accessories and be U.L.
Listed MPSA.
3. The frames shall be mitered corners for a neat and tight seam after
assembly.
4. Finish of the frames shall be prime painted. (Option: stainless
steel, baked enamel)
5. Manufacturer shall provide anchoring preparation as required for a
proper installation.
6. The frames shall be constructed to allow voice transmission between
the frame and glass by use of neoprene glass spacers 12" on centers
(Note to specifier, if sound transmission is not required or a
ULŪ Listed speak thru is to be installed in the glass, then specify the
frames to be prepared for sealed glazing).
2.3 Bullet Resistant Deal Trays
A. Materials - The deal tray for the bullet resistant teller windows will be
manufactured of Balistex(R) stainless steel in accordance with U.L. 752.
B. Construction -
1. The deal trays will be provided as indicated on
the approved drawings.
2. Each teller window will be provided with ________
deal tray(s) for each teller window unit.
3. Each deal tray will be of the appropriate design, material and
tolerances as required to maintain the protection level ________ as tested by
Underwriters Laboratories.
4. (Optional) The deal tray shall include a 6-1/2" ledge on the
exterior (and/or interior) side of the window. The ledge shall be
stainless steel and be part of the deal tray system.
5. The manufacturer of the framing shall provide the deal tray with
the frame and glass as a complete unit.
2.3 Bullet Resisting Glazing
A. Materials - The bullet resistant glazing shall be U.L. Listed for the ____
ballistic threat level and consist of laminated glass with polyvinyl interlayer
______" thick or equal. Glazing to be purchased with frame and deal
tray from window manufacturer to maintain ballistic quality assurance.
PART III EXECUTION
3.1 Site Work - The installer of the bullet resistant teller window assemblies will
be responsible to assemble the framing, anchor deal trays and framing to surrounding
wall (to be built by buyer) and install the bullet resistant glass for a
complete installation in accordance with the manufacturer's printed instructions. |
|